Plate mounting in flexographic printing, especially corrugated board postprint
tesa® 52332 is specially designed for demanding plate mounting applications, especially where high adhesion is required and where plates are mounted permanently. This is often the case in corrugated board postprint where plates are commonly mounted to e.g. Mylar sheets and hung vertically when stored.
- tesa® 52332 is ageing resistant
- tesa® 52332 has an embossed PP-liner to prevent the formation of air bubbles during plate mounting
tesa® 52332 is a plate mounting tape for flexographic printing, especially well suited to permanent mounting applications in corrugated board postprint.
|Type of adhesive||tackified acrylic|
|Type of liner||PP|
|Backing material||soft PVC|
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.