52310 [Country PI: ek]
[Country PI: ek]
PDF – 41.9 kB
tesa® 52310 (transparent), tesa® 52315 (yellow), tesa® 52320 (white) and tesa® 52325 (pink) are a range of tesaprint® plate mounting solutions, each of a different thickness category.
The unwind characteristics of all four tapes offer easier tape mounting. The structured PP-liner also prevents the formation of air pockets when plate mounting. Plates are easily repositioned during mounting as the full adhesion of the tape only becomes effective during the print run.
The high adhesion and good shear resistance of these tapes ensure that there is no plate movement or edge lift, even at high speeds and on extended print runs. On demounting, there are no adhesive residues on the plate or the cylinder.
tesa® 52310 is also especially well suited to the mounting of photopolymer plates on compressible sleeves.
The mounting of photopolymer plates in flexographic printing, especially on compressible sleeves
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.
Choose a Region: