05_ttp39_FurnierstreifenKranz_AM_quer

Wood Veneer Christmas Wreath

Oak wood veneer edge trimmings give the shiny Christmas baubles an unusual hold - and cut a really good figure!

Level of difficulty Leisurely inspiration
Duration 60

We need:

3 rolls edge trimming in oak optics (wood band) 20 mm x 5 m scissors ruler pencil 34 mini Christmas baubles ø 2 cm ribbon for decoration tesa® Easy Cut Compact Desk Dispenser + tesafilm® Invisible

This Is How We Do It:

05_ttp39_FurnierstreifenKranz_001
01

For this DIY Christmas Wreath we need:
3 rolls edge trimming in oak optics (wood band) 20 mm x 5 m, scissors, ruler, pencil, 34 mini Christmas baubles ø 2 cm, ribbon for decoration, tesa® Easy Cut Compact Desk Dispenser + tesafilm® Invisible

 

Time: approx. 1 hour.

GIF_zuSTEP2_Furnierstreifen
02

For the 34 loops, cut 68 strips of wood band in a length of 14 cm. Place 2 strips with the insides on top of another and bend the ends into a loop. Be careful not to break the loops. Tear a 7-cm strip of tesafilm® from the dispenser.

05_ttp39_FurnierstreifenKranz_003
03

Wrap the loop ends tightly with tesafilm®. Make another 33 loops.

05_ttp39_FurnierstreifenKranz_004
04

Cut 3 x 70 cm strips. Bend a strip into a circle and fix it with tesafilm®. Now lay the other strips around the circle and fix them in several spots with tesafilm®. In the inner and outer rings, the wood sides are outside.

05_ttp39_FurnierstreifenKranz_005
05

Now attach the loops alternately on the inside and outside of the ring using tesafilm®. Continue until the circle is closed. Be very careful with the last loops so they don't break.

05_ttp39_FurnierstreifenKranz_006
06

Attach the ribbon, remove the caps from the baubles and put them in the loops.

tesa products required for this project