White board - mounting without drilling

Clean the surface for the screws thoroughly using a cloth with pure alcohol or water. Be sure to eliminate all dust and grease.

Measure out with the white board where to place the screws. Remove the protective film from the first screw.

Place the screw on the wall. With the initial low-grade adhesive, it will stay safely in place.

Now take the provided tube and fill adhesive into the larger hole. You can stop once the adhesive comes out the smaller hole. Repeat for the other screw.

Wait 12 hours for the adhesive to set. After that time, it will have reached its top strength.

Affix the white board to the screws. It will solidly hold for as long as you need it.

Now you can write your messages or notes on the board and wipe them off when they are no longer needed. With a magnetic board, you can even stick items such as doctor’s appointments to it.

It’s easy to take the board off again once it’s no longer required. Detach the white board itself. Twist each screw off sideways with pliers.

Use a scraper to remove any remaining adhesive. Not a trace will stay behind, leaving your wall just as it was before.