01
Clean the surface thoroughly. Make sure to remove all dust or grease by using a cloth with pure alcohol or water.
Motion sensor lamp - mounting without drilling
Simple and practical - how to mount a motion sensor lamp without drilling Especially outside your home, you want a light that goes on when somebody moves close to it – be that because somebody might not belong on your property or simply that you can rely on a light to find the right key. You can do that beautifully without drilling.
Level of difficulty
Original & quick
We need:
This is how we do it:
02
Use the lamp to determine where to position the screws. Take the protective film off the first screw.
03
Attach it to the wall. It will stick to the surface well enough for the next step.
04
Fill the adhesive from the included tube into the larger hole of the screw until it comes out the smaller hole. Do the same for the other screw.
05
Allow the adhesive 12 hours to set. It will then reach its maximum performance.
06
Connect the base piece of the lamp to the screws and fasten it tightly.
07
Now you only need to attach the motion sensor lamp to the base piece, and everything is ready.
08
Enjoy the light that will come on by itself whenever it detects motion in its range. You can always find the proper key on your chain to open your home door.
09
Removal is problem-free. After taking off the lamp, you only need pliers to twist the screws off the wall. They will come off well.
10
The final step is using a scraper to remove the left-over adhesive. Not a trace of the lamp will remain on your pristine surface.