01
What We need:
We need a small screen door made of natural wood (approx. 60 x 70 cm), white weatherproof varnish, paintbrush, small hooks, undercoat paint, glass lanterns, tesa Powerbond® OUTDOOR 5 m x 19 mm.
DIY plant and lantern holder
DIY plant and lantern holder
A simple lattice screen door can be transformed into a flower pot or lantern holder with tesa® Powerbond OUTDOOR and a little bit of imagination. This outdoor tape is weather resistant, making it perfect for garden fixing.
We need:
- a small screen door made of natural wood (approx. 60 x 70 cm)
- white weatherproof varnish
- paintbrush
- small hooks
- undercoat paint
- glass lanterns
- tesa® Powerbond OUTDOOR 5 m x 19 mm
Steps
tesa SE
Overview of materials.
tesa SE
Preparing the screen door with the undercoat.
02
Paint the screen door with the undercoat, then varnish on both sides.
tesa SE
Remove any dust and apply two strips of tesa Powerbond® OUTDOOR on the reverse. Press for five seconds.
03
Thoroughly remove any dust from the reverse and apply two strips of tesa Powerbond® OUTDOOR side by side on the top and bottom of the door. Strips should be placed in a vertical direction, at a distance of about 5 cm. Press firmly for five seconds.
tesa SE
Remove any dust from the surface.
04
Thoroughly remove any dust from the surface you're attaching to.
tesa SE
Take off the protective film.
05
Remove the protective film.
tesa SE
Install the door in the desired Position.
06
Place the door in the desired position and press firmly for five seconds. Hang the small lanterns on the door using hooks.
tesa SE
A simple lattice screen door can be transformed into a flower pot or lantern holder with tesa Powerbond® OUTDOOR and a little bit of imagination.
07
Enjoy your self-made plant and lantern holder!
