Additional Info
Before using our adhesion promoter, the bonding surface should be free of dust, grease, oil, moisture, and other contaminants. Therefore, we highly recommend cleaning the substrate with a lint-free cloth using solvents, such as ethanol or isopropanol or our tesa® 60040 Industry Cleaner.
Once the surface has been cleaned, you can go ahead and apply our tesa® 60153 Adhesion Promoter Fast Cure. We recommend applying our adhesion promoters with a melamin sponge or lint-free cloth. The entire surface should be evenly coated with adhesion promoter in order to reach the highest bonding performance. To ensure that the primer is fully dried, it is crucial to wait for a minimum of 30 seconds to 5 minutes (depending on the surrounding temperature and humidity), allowing ample time for solvents to evaporate. Please make sure to keep the prepared surface free of contaminants prior to applying the tape.
Once the substrate has been properly pre-treated with tesa® 60153 Adhesion Promoter Fast Cure, the open time for bonding should be several hours. Please note that due to the multitude of available substrate formulations in the marketplace, it is recommended to test our tesa® Adhesion Promoter prior to usage.
• The shelf life of this product amounts to at least 12 months when stored at room temperature in its sealed original container.
• For further information and advice on safe handling please refer to our safety data sheet (SDS), which is available upon request.
Once the surface has been cleaned, you can go ahead and apply our tesa® 60153 Adhesion Promoter Fast Cure. We recommend applying our adhesion promoters with a melamin sponge or lint-free cloth. The entire surface should be evenly coated with adhesion promoter in order to reach the highest bonding performance. To ensure that the primer is fully dried, it is crucial to wait for a minimum of 30 seconds to 5 minutes (depending on the surrounding temperature and humidity), allowing ample time for solvents to evaporate. Please make sure to keep the prepared surface free of contaminants prior to applying the tape.
Once the substrate has been properly pre-treated with tesa® 60153 Adhesion Promoter Fast Cure, the open time for bonding should be several hours. Please note that due to the multitude of available substrate formulations in the marketplace, it is recommended to test our tesa® Adhesion Promoter prior to usage.
• The shelf life of this product amounts to at least 12 months when stored at room temperature in its sealed original container.
• For further information and advice on safe handling please refer to our safety data sheet (SDS), which is available upon request.