tesa® 60152 Adhesion Promoter PU/HPVC

Surface treatment to improve adhesion to PU and HPVC

Product description

tesa® 60152 Adhesion Promoter PU/HPVC can be used to improve the adhesion of tesa’s pressure-sensitive adhesive tape offering to polyurethane (PU) and hard polyvinyl chloride/PVC-U/rigid PVC (HPVC). It is especially recommended for our tesa® ACXplus product family. The UV-traceability of our tesa® ACXplus Adhesion Promoter allows easy quality control during the application process.

Application Fields

Our tesa® 60152 Adhesion Promoter is recommended for PU and HPVC only. This product can be used to significantly improve the bonding strength of tesa® ACXplus tapes. Testing shows significantly higher peel adhesion values.

Product Construction

Color yellow

Properties / Performance Values

Consistency liquid
Spreading rate ca. 15 m²/l
Solids 10 %
Density 0.76 g/cm³
Viscosity 9 mPa s

Additional Info

Before using our adhesion promoter, the bonding surface should be free of dust, grease, oil, moisture, and other contaminants. Therefore, we highly recommend cleaning the substrate with a lint-free cloth using solvents, such as ethanol or isopropanol alcohol or our tesa® 60040 Industry Cleaner.

Once the surface has been cleaned, you can go ahead and apply our tesa® 60152 Adhesion Promoter. We recommend applying our adhesion promoters with a lint-free cloth, brush or sponge. Other than that, an applicator pen or felt applicator can be used. The entire surface should be coated thinly with adhesion promoter in order to reach the highest bonding performance. It is important to wait at least 2 minutes (and a maximum of 5 minutes) in order to give solvents time to evaporate. Please make sure to keep the prepared surface free of contami-nants prior to applying the tape.

Once the substrate has been properly pretreated with tesa® 60152 Adhesion Promoter, the open time for bonding is several hours/days. Please note that due to the multitude of available substrate formulations in the marketplace, it is recommended to test our tesa® Adhesion Promoter prior to usage.
• The shelf life of this product amounts to at least 12 months when stored at room tem-perature in its sealed original container.
• For further information and advice on safe handling please refer to our safety data sheet (SDS), which is available upon request.
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.

Related products