Installation Guide for tesa® Power.Kit Technology

Once you have found the right place for mounting, you should clean this area intensively. Only on surfaces that are free of dust, grease, lime and dry will the combination of adhesive mass and adapter achieve maximum holding power.

Use a clean, soft cloth for basic cleaning. Please do not use any non-stick cleaning agents or cleaners containing silicone, as these substances impair the adhesive effect. After basic cleaning, clean with rubbing alcohol. If a cleaning cloth is included with your accessory, please use it.

If you want to play it safe, wipe the area again with a dry, soft and clean cloth.

In our assortment you will find various adapters to properly mount the bathroom accessories. Among other things, they are used for fixing toilet paper holders, toilet brush sets, towel hooks and soap dispensers.

All adapters are similar in design and work on the same principle: first remove the protective film of the adhesive ring. Press the adapter firmly to the surface for a few seconds. If you are mounting a bathroom accessory with two adapters, make sure that the distance between the adapters is correct and they are aligned correctly.

Info: Be careful not to touch the adhesive surface of the adapter with your fingers. Otherwise, new grease could get onto the surface and reduce the load-bearing capacity.

Now hold the applicator in the larger opening of the adapter. Now carefully squeeze the adhesive out of the applicator and fill the ring with the adhesive mass until it appears at the smaller hole of the adapter.

Important: Please do not press or touch the adapter now! Cavities could be created that impair the holding force.

To ensure maximum holding power, please wait 12 hours. The adhesive is then completely cured.
If adhesive mass protrudes from the sides of the adapter, you can carefully remove it. 

Now attach the bathroom accessory to the adapter by fixing the accessory with the tiny screw.

The disassembly of the adhesive adapter is as easy as the assembly! First unscrew the bath accessory from the adapter.
Now grasp the adapter ring with a pipe wrench and simply turn it clockwise carefully from the wall.

If adhesive residue remains on the surface, you can gently scrape it off with a thin spatula or scraper.

Voila! Your tiles are as clean as before and not damaged.

Note: You do not have to dispose of the bathroom accessory, you can reuse it with a new adapter. So ideal if you want to redecorate your bathroom!