88111 [Master PI]
PDF – 42.2 kB
1.1 mm (43 mil) tesaprint® cushioning foam pre-laminated PET
tesa® 88111 is a white closed-cell PE foam, equipped with an acrylic adhesive and a pre-laminated PET carrier film (250 µm / 10 mil).
It is especially designed to add a compressible layer to the compound of printing plate and carrier film when printing directly on corrugated board (Flexo Postprint).
The outstanding foam quality will ensure excellent print quality, especially in combination with thinner printing plates. It also provides long-term resilience and outstanding resistance against water and solvents.
To use this pre-laminated PET version of our tesaprint® cushioning foams, simply mount your printing plate to the PET carrier film by using a double-sided tesaprint® plate mounting tape.
Compressible substructure for Postprint printing plates
pre-laminated PET (250 µm)
tesa® products prove their impressive quality day in, day out in demanding conditions and are regularly subjected to strict controls. All technical information and data above mentioned are provided to the best of our knowledge on the basis of our practical experience. They shall be considered as average values and are not appropriate for a specification. Therefore tesa SE can make no warranties, expressed or implied, including, but not limited to any implied warranty of merchantability or fitness for a particular purpose. The user is responsible for determining whether the tesa® product is fit for a particular purpose and suitable for the user’s method of application. If you are in any doubt, our technical staff will be glad to support you.
Choose a reagion: