The smart way to mount things on rough, solid surfaces like brickwork and masonry.
Click through the tabs above this step-by-step video to see how quick and easy it is to get your projects – and your possessions – off the ground.
It used to be a big undertaking to get a couple of screws into rough surfaces like brick walls. Now you don’t even have to roll up your sleeves. There’s no mess, no noise - and no holes to fill in when you want to remove them.
Grease, dirt and grit can get in the way of a good, strong bond, so use a brush to give rough surfaces like brickwork a clean.
Removing the protective film from the rim of the screws will expose the adhesive surfaces. Attach the screws on a smooth and even spot in the desired area. You don’t need to push too hard – just lightly press the screws to the surface so they stay in position.
Use the tip of the red key to pierce the tube’s nozzle, and then slide the other end of the tube through the key as shown.
Insert the nozzle into the larger of the two holes in each screw and turn it to squeeze the adhesive into the cavity until the formula starts coming out of the smaller hole. There’s no need to press down on the screw – just wait for 12 hours to let the nie wieder bohren. Technology set.
Now you’ve got a good solid mount (or two, if you’re using two) that’s ideal for putting up a wire shelf on which to store your decorating tools. Adhesive Screws can be used for pretty much anything though, from humble hosepipe holders to more sophisticated spice racks. Each one will support up to 10kg, and of course two of them will handle twice that load.
We’ve designed nie wieder bohren. Technology to be really tough when it needs to be but not when it comes to removal. This means that uninstalling one of these Adhesive Screws could hardly be simpler. Just take an adjustable wrench and gently twist the screws from the wall!