Festival drink holder made with Duct Tape
Build a festival drink holder

Build a festival drink holder

Super practical for any festival: the homemade, wearable drink holder!



Steps

Festival drink holder made with Duct Tape Step 1
Festival drink holder made with Duct Tape Step 1

01

First the holder: to make it, you need to stick 5 strips of Gaffer tape that are about 35 cm long to each other. The adhesive surface needs to face upwards.

Festival drink holder made with Duct Tape Step 2
Festival drink holder made with Duct Tape Step 2

02

Then apply 8 strips of Gaffer tape about 25 cm long to the lower strips to create a mat.

Festival drink holder made with Duct Tape Step 3
Festival drink holder made with Duct Tape Step 3

03

Now cut the Gaffer tape mat to 20 cm x 30 cm with the hobby knife.

Festival drink holder made with Duct Tape Step 4
Festival drink holder made with Duct Tape Step 4

04

Now line up the short sides and join them together from inside and outside with a strip of Gaffer tape.

Festival drink holder made with Duct Tape Step 5
Festival drink holder made with Duct Tape Step 5

05

Now for the underside: create a square Gaffer tape mat by sticking 5 strips of tape together to make each side. The strips should be about 20 cm long.

Festival drink holder made with Duct Tape Step 6
Festival drink holder made with Duct Tape Step 6

06

Now use the hobby knife to cut out a circle with a diameter of 18 cm.

Festival drink holder made with Duct Tape Step 7
Festival drink holder made with Duct Tape Step 7

07

Place the holder on the circle and use the hobby knife to cut into the circle at several points.

Festival drink holder made with Duct Tape Step 8
Festival drink holder made with Duct Tape Step 8

08

Fold up these protruding ends and attach them to the holder on all sides using a piece of Gaffer tape.

Festival drink holder made with Duct Tape Step 9
Festival drink holder made with Duct Tape Step 9

09

Now for the strap: simply stick 2 strips of tape on top of one another. Make sure that one strip is longer than the other so that some adhesive surface remains free at both ends. The strips should be about 140 cm long for a shoulder strap.

Festival drink holder made with Duct Tape Step 10
Festival drink holder made with Duct Tape Step 10

10

Attach the strap to the holder with the adhesive surfaces.

Festival drink holder made with Duct Tape Step 11
Festival drink holder made with Duct Tape Step 11

11

So that everything stays together, wrap another strip of tape around the holder.

Festival drink holder made with Duct Tape Step 12
Festival drink holder made with Duct Tape Step 12

12

Now the festival drink holder is finished – cheers!

Our Festival Tape Products Featured in this Tip: